GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 GMC C Pickup - 2WD 🢒 Engine 🢒 Engine Mechanical - 6.5L 🢒 Valve Lifter Replacement

Removal Procedure

    Object Number: 59806 Size: SH
  1. Disconnect both the battery negative cables from the batteries. Refer to Battery Replacement in Engine Electrical.
  2. Remove the cylinder head from the engine block. Refer to Cylinder Head Replacement .
  3. Remove the valve lifter retainer and bolt from the engine block

    4. Object Number: 59809 Size: SH
  4. Remove the valve lifter guide from the engine block.

    5. Object Number: 309558 Size: SH

    Important: Some engines will have both standard and 0.010 inch oversize valve lifters. The oversize valve lifter will have a "10" etched on the cast pad adjacent to the valve lifter bore and on the top rail of the cylinder case above the valve lifter.

  5. Remove the valve lifters from the engine block.
  6. Place the valve lifters, valve lifter guides, and retainer and bolt in a organizer rack

Installation Procedure
  1. Apply a small amount of GM P/N 1052365 lubricant to the valve lifter roller bearings.

    2. Important: Coat the lifters with clean engine oil before installing the lifters in the lifter bores.


    Object Number: 309558 Size: SH
  2. Install the new valve lifters to the engine block.

    3. Object Number: 59809 Size: SH
  3. Install the valve lifter guide to the engine block.

    4. Object Number: 59806 Size: SH

    Important: After all the retainers are installed, turn the crankshaft by hand two full revolutions, to ensure free movement of the valve lifters in the guide. If the engine will not turn over by hand, one or more of the valve lifters may be binding in the guide.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the valve lifter retainer and bolt to the engine block.

    5. Tighten
    Tighten the bolts to 26 N·m (18 lb ft).

  5. Install the cylinder head assembly to the engine block. Refer to Cylinder Head Replacement .
  6. Connect both the battery negative cables to the batteries. Refer to Battery Replacement in Engine Electrical.