NOTICE: Whenever performing repairs to the wheel speed sensor, wheel speed sensor mounting bracket, steering arm, front caliper anchor plate, steering knuckle, inner bearing dust shield or any attaching fasteners, the wheel speed sensor air gap may be moved out of adjustment. Ensure proper wheel speed sensor air gap to prevent damage to the wheel speed sensor and to insure the proper operation of the antilock brake system.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: Do not install washers between the attaching nuts and the wheel speed sensor mounting bracket, or insufficient thread engagement may occur.

Tighten
Tighten the attaching nuts to 285 N·m (210 lb ft).