Tools Required

J 23523-F Crankshaft Balancer Remover

1. Disconnect the battery negative cable. Refer to Battery Cable Replacement in Engine Electrical.
2. Remove the fan shrouds from the radiator. Refer to Fan Shroud Replacement in Engine Cooling.
3. Remove the drive belt from the vehicle. Refer to Drive Belt Replacement .
4. Remove the cooling fan from the water pump. Refer to Fan Replacement in Engine Cooling.
5. Remove the crankshaft pulley from the crankshaft balancer.



6. Remove the crankshaft balancer bolt and the washer.



7. Use the J 23523-F and remove the crankshaft balancer from the crankshaft.

Tools Required

J 23523-F Crankshaft Balancer Remover

1. Apply clean engine oil to all of the sealing surfaces.
2. Ensure that the key is in the keyway.
3. Use a mallet in order to tap the crankshaft balancer on the crankshaft.
4. Use the J 23523-F and install the crankshaft balancer.
5. Remove theJ 23523-F from the crankshaft balancer.



6. Install the crankshaft balancer bolt and washer.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Tighten the crankshaft balancer bolt.

Tighten
Tighten the crankshaft balancer bolt to 270 N·m (200 lb ft).




8. Install the crankshaft pulley to the crankshaft balancer.

Tighten
Tighten the pulley bolts to 40 N·m (30 lb ft).

9. Install the cooling fan to the water pump pulley. Refer to Fan Replacement in Engine Cooling.
10. Install the drive belt on the pulleys. Refer to Drive Belt Replacement .
11. Install the fan shrouds to the radiator. Refer to Fan Shroud Replacement in Engine Cooling.
12. Connect the battery negative cables to the batteries. Refer to Battery Cable Replacement in Engine Electrical.