Spring Hanger Replacement Front Hanger

Important: Both the rear and the front rear spring hangers are installed the same way. The front spring hanger requires the removal of the frame rivets.

1. Set the parking brake.
2. Block the front wheels.
3. Raise the frame until the tension is released from the spring and the hanger bolt.
4. Remove the following components from the spring and the hanger:

•	The spring eye bolt nut (6)

•	The washers

•

The bolt

5. Remove the spring hanger rivets, if equipped.



6. Remove the following components from the side member (4):

•	The spring hanger nuts (2)

•	The washers (3,5)

•	The bolts (6)

•	The spring hanger (1)

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the hanger to the side member with the following parts:

•	The bolts (6)

•	The washers (3,5)

•	The nuts (2)

Tighten
Tighten the spring hanger nut to 70 N·m (52 lb ft).

2. Raise the spring in order to align the spring eye and spring hanger holes.



3. Install the following components in the spring and the hanger:

•	The spring eye bolt (6)

•	The washers

•

The nut

4. For tapered leaf springs, install the following components:

•	The rear spring hanger rebound bolt

•	The washer

•

The nut

Tighten
Tighten the rear spring hanger bolt to 415 N·m (305 lb ft).

5. For multileaf springs, install the rear spring hanger bolt.

Tighten
Tighten the rear spring hanger bolt. Ensure that a minimum of 84.07 mm (3.36 in) is between the ears of the rear spring hanger.

6. Lower the vehicle.
7. Remove the blocks from the wheels.