Tools Required

1. Remove the universal joint. Refer to Universal Joint Replacement .



2. Remove the yoke nut or bolt and the washers. Using the J 3453 .



3. Remove the yoke using the J 7804-A .

Important: 

•	Ensure that the splines are aligned and the yokes are in phase. Refer to Propeller Shaft Phasing Description .

•	Tap on the yoke in order to ensure that the yoke is completely seated against the propeller shaft.

1. Install the yoke (2).

Notice: Refer to Fastener Tightening Specifications in the Preface section.

2. Install the yoke nut or bolt and the washers (1).
3. Install the universal joint. Refer to Universal Joint Replacement .