This radiator uses an aluminum core (1) with plastic core tanks (4, 9).

The core tanks house the automatic transmission coolers (3) and the engine oil coolers (11), if equipped.

The drain cock (7) is located in the lower tank. The drain cock is serviceable.

This core is made of aluminum. The core is constructed with a crossflow design. The crossflow design uses large tubes, which resist plugging. Clinched tabs on the core attach the core to the tank.

Clinched tabs attach the tanks (4, 9) to the core. The clinched tabs are attached to the sides of the core. The clinched tabs can be bent back in order to allow removal of the tanks. Bend the tabs back only enough to remove the tank. Excessive bending weakens the tabs.

A high-temperature rubber gasket (2, 12) seals the mating surface between the core and the tank. Replace the gasket when a tank is removed from the core.

The aluminum/plastic radiator uses the following components: