For 1990-2009 cars only
Removal Procedure
- Raise the vehicle.
- Remove the transmission. Refer to Transmission Replacement in manual transmission.
- Mark the flywheel, cover plate, and pressure plate for installation alignment.
- For vehicles equipped with 14 inch single pull type clutch systems, remove the bolts and washers securing the clutch assembly to the flywheel.
- For vehicles equipped with 14 inch double pull type clutch systems, remove the bolts and washers securing the clutch assembly to the flywheel.
- For vehicles equipped with 14 inch Eaton--Valeo pull type clutch systems, remove the bolts and washers securing the clutch assembly to the flywheel.
Installation Procedure
- For vehicles equipped with 14 inch Eaton--Valeo pull type clutch systems, install the bolts and washers securing the clutch assembly to the flywheel.
- For vehicles equipped with 14 inch double pull type clutch systems, install the bolts and washers securing the clutch assembly to the flywheel.
- For vehicles equipped with 14 inch single pull type clutch systems, install the bolts and washers securing the clutch assembly to the flywheel.
- Install the transmission. Refer to Transmission Replacement in manual transmission.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 54 N·m(40 lb ft).
