GM Service Manual Online
For 1990-2009 cars only

Steering Gear Housing Plug Replacement - Off Vehicle Saginaw - 710 Model

Disassembly Procedure


    Object Number: 446919  Size: SH
  1. Unseat the retaining ring (3) from the primary and secondary cylinders using a needle nose punch (1) and a screwdriver.
  2. Pry the retaining ring (3) out of the housing groove using a screwdriver (2).

  3. Object Number: 446923  Size: SH
  4. Turn the housing end plug (2) counterclockwise until the housing end plug (2) is forced out of the cylinder (1).

  5. Object Number: 446926  Size: SH
  6. In order to remove the housing O-ring seal, turn the stub shaft counterclockwise until the primary rack piston (1) covers the crossover hole (2).

  7. Object Number: 740387  Size: SH
  8. Remove and discard the housing O-ring seals (2) and (10).
  9. Remove the rack piston rings (3) and (9).
  10. Remove and discard the rack piston O-ring seals (4) and (8).
  11. Important: Observe the head of the rack piston plugs (5) and (7). If the head of the rack piston is an aluminum square drive head, firmly tap the head using a hammer and a brass drift. If the head of the rack piston is a steel hexagon head, remove the rack piston plugs (5) and (7) with a 1 inch socket.

  12. Remove the rack piston plugs (5) and (7) from the rack piston by turning the rack piston plugs (5) and (7) counterclockwise.

Assembly Procedure


    Object Number: 740387  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the rack piston plugs (5) and (7).
  2. Tighten
    Tighten the rack piston plugs to 150 N·m (111 lb ft).

  3. Lubricate and install the new rack piston O-ring seals (4) and (8).
  4. Lubricate and install the rack piston rings (3) and (9).
  5. Lubricate and install the new the housing O-ring seals (2) and (10).
  6. Install the housing end plugs (1) and (11).

  7. Object Number: 446929  Size: SH
  8. Install the housing end plug retaining ring (2). The ring gap (1) does not line up with the steering gear housing hole (3).