Tools Required

J 41352 Modular Column Holding Fixture

1. Install the dimmer switch assembly (2) onto the ignition switch assembly (1).
2. Install the dimmer switch actuator rod (5) into the slot on the dimmer switch assembly (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: You must remove all the lash from the dimmer switch actuator rod before tightening any screws.

3. Install the washer head screw (3).
4. Install the hexagon nut (4) onto the dimmer and ignition switch mounting stud.

Tighten

•	Tighten the screw to 4 N·m (35 lb  in).

•	Tighten the nut to 4 N·m (35 lb in).




5. Remove the steering column and J 41352 from the vise.