The Engine Scan Tool Data List contains all engine related parameters that are available on the scan tool. The list is arranged in alphabetical order. A given parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together.
Use the Engine Scan Tool Data List only after the following is determined:
| • | Powertrain On-Board Diagnostic System Check is completed. |
| • | No Diagnostic Trouble Codes (DTCs). |
| • | On-Board diagnostics are functioning properly. |
Scan tool values from a properly running engine may be used for comparison with the engine you are diagnosing. The Engine Scan Tool Data List represents values that would be seen on a normal running engine.
Important: A scan tool that displays faulty data should not be used. The scan tool concern should be reported to the manufacturer. Use of a faulty scan tool can result in misdiagnosis and unnecessary parts replacement.
Only the parameters listed below are referenced in this service manual for use in diagnosis. If all values are within the typical range described below, refer to Driveability Symptoms for diagnosis.
The column labeled Data List indicates where a parameter can be located on the scan tool. Refer to the scan tool operating manual for the exact locations of the data lists. The following is a description of each term listed:
All: The Parameter is in all data lists indicated below.Eng 1: Engine Data 1 List
Eng 2: Engine Data 2 List
FT: Fuel Trim Data List
CC: Cruise Control Data
TAC: TAC Data List
Engine at Operating Temperature/Engine Idling in Closed Loop/ Closed Throttle/ Park or Neutral/ Acc. OFF | |||
|---|---|---|---|
Scan Position | Data List | Units Displayed | Typical Data Value |
A/C Status | Eng 2 | On/Off | Off |
Actual EGR Position | Eng 1 | Percentage | 0 % |
APP Average | Eng 1, Eng 2, FT, CC, TAC | Counts | Varies |
APP Indicated Angle | Eng 1, Eng 2, FT, CC, TAC | Percentage | Varies |
APP Sensor 1 | TAC | Volts | 0.25-1.1 volts |
APP Sensor 2 | TAC | Volts | 3.9-4.8 volts |
APP Sensor 3 | TAC | Volts | 3.2-4.5 volts |
APP Sensor 1 Angle | TAC | Percentage | Varies |
APP Sensor 2 Angle | TAC | Percentage | Varies |
APP Sensor 3 Angle | TAC | Percentage | Varies |
APP Sensor 1 and APP Sensor 2 (Disagree) | TAC | Yes/No | No |
APP Sensor 1 and APP Sensor 3 (Disagree) | TAC | Yes/No | No |
APP Sensor 2 and APP Sensor 3 (Disagree) | TAC | Yes/No | No |
APP Sensor 1 Out of Range | TAC | Yes/No | No |
APP Sensor 2 Out of Range | TAC | Yes/No | No |
APP Sensor 3 Out of Range | TAC | Yes/No | No |
BARO | Eng 1, FT | kPa | 65 - 104 kPa (varies w/Altitude) |
BARO | Eng 1, FT | Volts | 3.5-4.5 Volts (varies w/Altitude) |
CAM Signal Input - High to Low | Eng 1 | Counts | Varies |
CAM Signal Input - Low to High | Eng 1 | Counts | Varies |
CC Brake Switch | Eng 1, Eng 2, CC, TAC | Applied / Released | Released |
Clutch Switch | Eng 1 | Depressed/ Released | Released |
Commanded EGR | Eng 1 | Percentage | 0 % |
Cruise Disengage History 1-8 | CC | Refer to | Varies |
Cruise Requested | Eng 1, CC, TAC | Yes / No | No |
Cruise Resume / Accel | Eng 1, CC, TAC | On / Off | Off |
Cruise Switch | Eng 1, CC, TAC | Off / On | Off |
Cruise Set / Coast | Eng 1, CC, TAC | On / Off | Off |
Desired EGR Position | Eng 1 | Percentage | 0 % |
Desired Idle Speed | Eng 1, TAC | RPM | PCM Controlled |
DTC Set This Ignition | Eng 1, Eng 2, FT, TAC | Yes / No | No |
EGR Feedback | Eng 1 | Volts | 0.65 - 0.80 Volts |
EGR Closed Pintle Position | Eng 1 | Volts | 0.65 - 0.80 Volts |
Engine Oil Life Remaining | Eng 2 | Percentage | Varies |
Engine Oil Pressure | Eng 2 | kPa | 352-356 |
Engine Run Time | Eng 1, Eng 2 | Hrs, Min, Sec | Varies |
Engine Speed | Eng 1, Eng 2, FT, TAC | RPM | Varies |
EOP Sensor | Eng 2 | volts | 2.10-2.12 |
ETC | Eng 1, Eng 2, FT | °C/°F | Varies |
EVAP Canister Purge | Eng 1 | Percentage | 0 % |
Fuel Trim Cell | Eng 1, FT | 0 - 20 | Varies |
Fuel Trim Diagnostic Inhibit | FT | Enable/Disable | Disable |
Fuel Trim Learn | Eng 1, Eng 2, FT | Enabled / Disabled | Enabled (may toggle) |
HO2S Bank 1 Sensor 1 | Eng 1, FT | Millivolts | 10 - 1000 mV and Varying |
HO2S Bank 2 Sensor 1 | Eng 1, FT | Millivolts | 10 - 1000 mV and Varying |
IAT Sensor | Eng 1, Eng 2, FT | °C/°F | Varies |
Ignition 1 | Eng 1, Eng 2 | Volts | 0-25 Volts |
Injector PWM Average Bank 1 | Eng 2, FT | Milliseconds | 1-4 |
Injector PWM Average Bank 2 | Eng 2, FT | Milliseconds | 1-4 |
Knock Retard | Eng 1, FT | 0.0° - 16° | Varies |
Knock Signal Present | Eng 1, Eng 2 | Yes/No | No |
Loop Status | Eng 1, Eng 2, FT | Open / Closed | Closed |
Long Term FT Bank 1 | Eng 1, Eng 2, FT | Percentage | Varies |
Long Term FT Bank 2 | Eng 1, Eng 2, FT | Percentage | Varies |
Long Term FT Bank 1 | Eng 1, Eng 2, FT | Counts | Varies |
Long Term FT Bank 2 | Eng 1, Eng 2, FT | Counts | Varies |
Long Term FT 1 Average | FT | Percentage | Varies |
Long Term FT 2 Average | FT | Percentage | Varies |
MAF Frequency | Eng 2 | 0-3199 Hz | Varies |
MAF Sensor | Eng 1, Eng 2, TAC | Grams Per Seconds (g/s | 5-9 g/s (varies w/Altitude) |
MAP Sensor | Eng 1, Eng 2, TAC | kPa | 20 - 48 kPa (varies w/Altitude)) |
MAP Sensor | Eng 1, Eng 2, TAC | Volts | 1.0-2.0 Volts (varies w/Altitude) |
MIL | Eng 1, Eng 2 | Off / On | Off |
Mileage Since DTC Cleared | Eng 2 | km/Miles | Varies |
PCM Reset | Eng 2 | Yes/No | No |
Reduced Engine Power | Eng 2, FT, CC, TAC | Active/Inactive |
Inactive |
Short Term FT Bank 1 | Eng 1, Eng 2, FT | Counts | Varies |
Short Term FT Bank 2 | Eng 1, Eng 2, FT | Counts | Varies |
Short Term FT Bank 1 | Eng 1, Eng 2, FT | Percentage | Varies |
Short Term FT Bank 2 | Eng 1, Eng 2, FT | Percentage | Varies |
Short Term FT 1 Average | Eng 1, Eng 2, FT | Percentage | Varies |
Short Term FT 2 Average | Eng 1, Eng 2, FT | Percentage | Varies |
Spark | Eng 1, Eng 2, FT | Degrees | Varies |
Startup ETC | Eng 1 | °C/°F | Varies |
TAC/PCM Communication | Eng 1, CC, TAC | Ok/Fault | Ok |
TP Desired Angle | Eng 1, Eng 2, FT, CC, TAC | Percentage | 3 - 10 % |
TP Indicated Angle | Eng 1, Eng 2, FT, CC, TAC | Percentage | 3 - 9 % |
TP Sensors Disagree | TAC | Yes/No | No |
TP Sensor 1 Out of Range | TAC | Yes/No | No |
TP Sensor 2 Out of Range | TAC | Yes/No | No |
TP Sensor 1 | TAC | Volts | 0.25-1.5 volts |
TP Sensor 2 | TAC | Volts | 3.0-1.5 volts |
Vehicle Speed | Eng 1, Eng 2, FT, CC, TAC | km/h/mph | Varies |
Warn-Ups w/o Emission Faults | Eng 2 | Counts | Varies |
Warm-Ups w/o Non-Emission Faults | Eng 2 | Counts | Varies |
