GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 GMC C-Series Medium Duty Truck B7 🢒 Brakes 🢒 Air Drums 🢒 Rear Cam Brake Assembly Replacement

Removal Procedure
  1. Block the wheels.
  2. Drain all air reservoirs. Refer to Draining Reservoirs in Air Brakes.

    3. Object Number: 201768 Size: SH
  3. Cage the rear air brake chamber. Refer to Caging the Rear Air Brake Chamber .
  4. Raise and support the rear axle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Remove the brake drum. Refer to Brake Drum Replacement .
  7. Remove the hub assembly. Rear Hub and Bearing Replacement in Rear Drive Axle.
  8. Remove the air line from the rear air brake chamber. Refer to the following procedure:
    9. •  Hose and Line Replacement - Nylon and Metal Compression
    •  Hose and Line Replacement - Nylon Push-In Type Fitting
    •  Hose and Line Replacement - Flexible
  9. Remove the wheel speed sensor, if equipped. Refer to Rear Wheel Speed Sensor Replacement in Antilock Brakes.
  10. Remove the bolts and the washers.
  11. Remove the rear brake assembly from the rear axle.

Installation Procedure

    Object Number: 201768 Size: SH
  1. Install the rear cam brake assembly to the rear axle.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the washers and the bolts.

    3. Tighten
    Tighten the rear cam brake assembly bolts to 220 N·m (162 lb ft).

  3. Install the wheel speed sensor, if equipped. Refer to Rear Wheel Speed Sensor Replacement in Antilock Brakes.
  4. Install the air line to the rear air brake chamber. Refer to
    5. •  Hose and Line Replacement - Nylon and Metal Compression
    •  Hose and Line Replacement - Nylon Push-In Type Fitting
    •  Hose and Line Replacement - Flexible

  5. Install the hub assembly. Rear Hub and Bearing Replacement in Rear Drive Axle.

    Install the brake drum. Refer to Brake Drum Replacement .

  6. Adjust the rear wheel bearings, if needed. Refer to Wheel Bearing Adjustment .
  7. Install the tire and wheel assembly. Refer to
  8. Tire and Wheel Removal and Installation
  9. Remove the safety stands and lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  10. Start the engine.
  11. Charge the air system to the air compressor governor valve cut-out point.
  12. Check for proper brake operation.
  13. Stop the engine.
  14. Apply the parking brake.
  15. Remove the wheel blocks.