GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 GMC C-Series Medium Duty Truck B7 🢒 Steering 🢒 Steering Wheel and Column - Standard 🢒 Ignition Lock Cylinder Case Replacement - On Vehicle

Removal Procedure
  1. Remove the steering column lock cylinder set. Refer to Ignition Lock Cylinder Replacement - On Vehicle .

    2. Object Number: 382893 Size: SH
  2. Remove the thrust washer.

    3. Object Number: 382896 Size: SH
  3. Remove the 4 hex washer head tapping screws (1) from the lock housing cover assembly (2).
  4. Remove the lock housing cover assembly (2) from the steering column jacket assembly (4).
  5. Remove the floor shift bowl (3) from the jacket assembly (4) with the switch actuator rod still attached.

    6. Object Number: 382897 Size: SH
  6. Remove the 3 pan head 6-lobed socket screws (3).

    7. Object Number: 382898 Size: SH
  7. Remove the upper bearing retainer (3).
  8. Remove the bearing retaining bushing (2).
  9. Remove the bearing assembly (1).

Installation Procedure

    Object Number: 382899 Size: SH
  1. Lubricate and install the bearing assembly (1).
  2. Install the bearing retaining bushing (2).
  3. Install the upper bearing retainer (3).

    4. Object Number: 382897 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the 3 pan head 6-lobed socket screws (3) through the bowl assembly (2), into the lock housing cover assembly (1).

    5. Tighten
    Tighten screws to 3.5 N·m (31 lb in).


    Object Number: 382896 Size: SH
  5. Install the floor shift bowl (3) with the lock housing cover assembly (2) onto the steering column jacket assembly (4). The switch actuator rod should still be attached.
  6. Install the 4 hex washer head tapping screws (1) into the lock housing cover assembly (2).

    7. Tighten
    Tighten the screws to 5.3 N·m (47 lb in).


    Object Number: 382893 Size: SH
  7. Install the thrust washer.
  8. Install the steering column lock cylinder set. Refer to Ignition Lock Cylinder Replacement - On Vehicle .