Removal Procedure
- Raise and suitably support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
- Support the transmission with safety stands.
- Remove the engine rear mount bolt, washer, mount, and spacer.
- Slightly raise the transmission, if necessary.
- Remove the engine rear mount bracket bolts and washers.
- Remove the engine rear mount bracket bolts and washers.
- Remove the engine rear mount bracket.
Installation Procedure
- Install the engine rear mount bracket.
- Install the engine rear mount bracket washers and bolts.
- Install the engine rear mount bracket washer and bolts.
- Lower the transmission, if necessary.
- Install the engine rear mount spacer, mount, washer, and bolt.
- Remove the transmission safety stands.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 50 N·m (37 lb ft).
Tighten
Tighten the bolts to 50 N·m (37 lb ft).
Tighten
Tighten the bolt to 50 N·m (37 lb ft).
