1. Set the park brake switch to the APPLY position.
2. Observe the park brake pump motor operation.

Does the park brake pump motor run?

--

Go to Step 2

Go to Park Brake Pump Motor Does Not Run

Check actuator movement during park brake pump motor operation.

Does the actuator extend normally?

--

Go to Park Brake Pressure Sensor Circuit Check

Go to Step 3

1. APPLY, then RELEASE the park brake switch.
2. Verify that the park brake pressure solenoid valve clicks.

Does the solenoid click?

--

Go to DTC 09 Park Brake System Pressure Leak-Down

Go to Step 4

1. Disconnect the park brake pressure solenoid valve connector.
2. Turn the ignition switch to the RUN position.
3. Connect a DMM from CKT 1931 (YEL/BLK) to chassis ground.
4. Measure the voltage.

Is the voltage reading more than the stated value?

10.0 Volts

Go to Step 5

Go to Step 8

Connect a DMM from CKT 150 (BLK) to ground.

Does the test lamp light?

--

Go to Step 6

Go to Step 7

Replace park brake pressure solenoid valve. Refer to Park Brake Solenoid Valve Replacement .

Is the repair complete?

--

System OK

--

Locate and repair open in CKT 150 (BLK) between G101 (Diesel), or G111 (Gas) and terminal B in the park brake pressure solenoid valve harness connector.

Is the repair complete?

--

System OK

--

Locate and repair open in CKT 1931 (YEL/BLK) between S232 and the park brake pressure solenoid valve.

Is the repair complete?

--

System OK

--