Refer to the below data tables when one of the following conditions exist:
• | The Instrument Cluster Diagnostic System Check is complete. |
• | The on board diagnostics are operating correctly. |
• | No diagnostic trouble codes (DTCs) are displayed. |
The typical scan tool data values are an average of the displayed values recorded from normally operating vehicles. The typical scan tool data values are intended to represent what a normally functioning system would display with certain preliminary settings. The values you get may vary slightly due to a low battery charge or other reasons. But the values should be very close.
Use only the parameters listed in the tables for diagnosis. If a scan tool reads other parameters, the values are not recommended for use in diagnosis. Refer to the Scan tool data definitions for further detailed information.
Preliminary Settings: The following preliminary settings must be set in order to achieve the same typical data values listed in the table.
Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
---|---|---|---|
Park brake set with the ignitions switch OFF / Ignition Switch in RUN / Engine running / Automatic Transmission in PARK / Manual Transmission in NEUTRAL / Air Conditioning is OFF | |||
Important:: The output table shown below does not list all of the IPC LEDs. The IPC LEDs not listed are controlled by a different device. Refer to the applicable device when diagnosing IPC LEDs not shown in the table below. | |||
4WD | Outputs | OFF | OFF |
ABS Lamp | Outputs | OFF | OFF |
Battery | Outputs | OFF | OFF |
Battery Voltage | Data | Volts | 12.0 - 14.7 Volts (varies with the vehicle) |
Brake Lamp | Outputs | OFF | OFF |
Cargo Lamp On | Outputs | OFF | OFF |
Change Engine Oil | Outputs | OFF | OFF |
Check Coolant Temp | Outputs | OFF | OFF |
Check Eng Oil Level | Outputs | OFF | OFF |
Check Engine Temp | Outputs | OFF | OFF |
Cruise Control | Outputs | OFF | OFF |
Dimming | Inputs | Active / Inactive | Active (when the park lamps are ON) |
Displayed Coolant Temperature | Data | Degrees Fahrenheit (°F) / Celsius (°C) | 190°F (87°C) |
Displayed Fuel Level | Data | Percentage (%) | 0-100% (Varies with the fuel tank level) |
Displayed Odometer Mile | Data | Miles / Kilometers | XXX,XXX Miles (Varies with the mileage of the vehicle) |
Displayed Trans Oil Temperature | Data | Degrees Fahrenheit (°F) / Celsius (°C) | 100°F (37.78°C) |
Displayed Trip Odometer | Data | Miles / Kilometers | XXX,XXX Miles (Varies with the mileage of the vehicle |
Engine Speed | Data | Revolutions Per Minute (RPM) | 500-700 RPM (Varies with the vehicle) |
Fasten Seat Belts | Outputs | OFF | OFF |
High Beam Lamp | Outputs | OFF | OFF |
Hour Meter | Data | Hours | XXX Hours (Varies with the Hours of the vehicle |
Low Coolant | Outputs | OFF | OFF |
Low Fuel Lamp | Outputs | OFF | OFF |
Low Washer Fluid | Outputs | OFF | OFF |
Module Part number | Module Information | Numeric | XXXXXXXXX (Varies with the vehicle) |
Monitored Coolant Temperature | Data | Degrees Fahrenheit (°F) / Celsius (°C) | 190°F (Fluctuates range 180-200°F) 87°C (Fluctuates range 82-93°C) |
Monitored Fuel Level | Data | Percentage (%) | 0-100% (Varies with the fuel tank level) |
Monitored Trans Oil Temperature | Data | Degrees Fahrenheit (°F) / Celsius (°C) | 100°F (37.78°C) |
Oil Pressure Lamp | Outputs | OFF | OFF |
Overspeed Lamp | Outputs | OFF | OFF |
Park Switch | Inputs | Open / Closed | Closed |
PRNDL STATE | Inputs | Park / Reverse / Neutral / Drive / Third / Second / First / Invalid | Park |
Reduce Engine Power | Outputs | OFF | OFF |
Security Lamp | Outputs | OFF | OFF |
Service 4WD | Outputs | OFF | OFF |
Service Throttle Soon | Outputs | OFF | OFF |
Tow / Haul | Outputs | OFF | OFF |
Trans. Fluid Hot | Outputs | OFF | OFF |
Trans. Hot ... Idle Engine | Outputs | OFF | OFF |
Trip Reset Switch | Inputs | Active / Inactive | Inactive |
Upshift Lamp | Outputs | OFF | OFF |
Vehicle Speed | Data | Miles Per Hour (MPH) / Kilometers | 0 MPH |
Wait to Start | Outputs | OFF | OFF |
Water in Fuel | Outputs | OFF | OFF |