Circuit Description
The fuel manager/filter assembly consists of the fuel heater, the water-in-fuel sensor, and a filter. The filter contains the coalescer, the device that combines small droplets of water into larger ones, and the filter/separator.
As fuel enters the filter, the fuel passes first though the fuel heater. The heater contains a thermostatic switch that opens or closes to turn the heater OFF or ON, depending on the temperature of the fuel.
The fuel then passes through the filter and the water coalescer, where the droplets of water in the fuel combine into larger drops that fall into the water reservoir in the filter. When fuel flows from the fuel manager/filter assembly to the injection pump, the fuel is clean and free of water.
The fuel heater is operated by a built-in thermostatic switch. The thermostatic switch completes the circuit for the fuel heater element when the thermostatic switch senses a temperature below 8°C (46°F).
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step checks for a fuel heater that is stuck ON.
-
This steps checks for a thermostatic switch that completes the circuit.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Engine Controls Schematics | ||||
1 | Does the Water In Fuel lamp operating properly? | -- | Go to Step 2 | Go to Water-in-Fuel Lamp Inoperative or Water-in-Fuel Lamp Always On |
Does heat occur? | -- | Go to Step 4 | Go to Step 3 | |
Does the thermostatic switch turn ON when the temperature is within the specified range? | -8.4-15.4 °C (16.9-59.8 °F) | Go to Step 5 | Go to Step 4 | |
4 | Replace the fuel heater. Refer to Fuel Filter Assembly Replacement . Did you complete the replacement? | -- | Go to Step 5 | -- |
5 | Operate the vehicle under which the problem was noted. Does the system operate properly? | -- | System OK | Go to Step 1 |
