Important:
• The shift cable is a two piece shift cable. • The front half (column end) or rear half (transmission end) of the
shift cable can be removed without removing the other end/half of the
shift cable. • Perform the part of this procedure that applies to the removal of that
half of the shift cable.
Depress both tangs on the conduit end fitting and push axially toward the rear of the vehicle.
Important: Do not reuse the existing removed E-clip. Discard the removed E-clip.
• | Steering Column Trim Covers Replacement - On Vehicle in Steering Wheel and Column - Standard |
• | Steering Column Trim Covers Replacement - On Vehicle in Steering Wheel and Column - Tilt |
Depress both tangs on the conduit end fitting and push axially toward the base of the column.
Important: Avoid unnecessary twisting/bending of the shift cable when removing the shift cable from the support.
• | Do not reuse the existing removed E-clip. |
• | Ensure the removed E-clip is discarded. |
• | The new front half (steering column end) of the shift cable will contain a new pre-installed E-clip. |
Important:
• The shift cable is a two piece shift cable. • The front or rear half of the shift cable can be removed without removing
the other half. • Perform the installation procedure that applies to the installation
of that half of the shift cable.
Ensure the tangs fully seat (snap) into the steering column bracket.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
• | Steering Column Trim Covers Replacement - On Vehicle in Steering Wheel and Column - Standard |
• | Steering Column Trim Covers Replacement - On Vehicle in Steering Wheel and Column - Tilt |
Pushing together the two ends of the shift cable will engage the inner wire and lock both cable wires together.
Important: This step must be performed correctly to avoid a misadjusted cable.
Do not grasp the shift cable end (2) during this procedure.Perform steps 26 through 28.
Important:
• Inspect shift lever pin for corrosion and replace if necessary. • The shift cable is a two-piece shift cable. • The front or rear half of the shift cable can be removed without removing
the other half. • Perform the installation procedure that applies to the installation
of that half of the shift cable.
Pushing together the two ends of the shift cable will engage the inner wire and lock both cable wires together.
Important:
• This step must be performed correctly to avoid a misadjusted cable. • Do not grasp the shift cable end (2) during this procedure.
Perform steps 19 through 21.