Tools Required
J 24319-B
Steering Linkage and Tie Rod Puller
Removal Procedure
- Raise the vehicle. Support the vehicle with suitable safety stands. Refer to
Lifting and Jacking the Vehicle
.
- Remove the tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation
.
- Remove the torque prevailing nut from outer tie rod stud.
- Loosen the jam nut (2) on the inner tie rod assembly (1).
- Remove the outer tie rod assembly (2) from the steering knuckle (1) using
J 24319-B
.
- Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).
Installation Procedure
- Connect the outer tie rod assembly (3) to the inner tie rod (1). Do not tighten the jam nut (2).
- Install the tie rod seal (2) to the outer tie rod assembly (1).
Notice: Refer to Fastener Notice in the Preface section.
- Connect the outer tie rod assembly (1) to the steering knuckle (2).
- Install the torque prevailing nut (3) to the outer tie rod stud (1).
Tighten
Tighten the torque prevailing nut (3) to 50 N·m (37 lb ft).
Important: Be sure the rack and pinion boot is not twisted after the toe adjustment.
- Check the wheel alignment. Refer to
Wheel Alignment Measurement
.