Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 4 TORX® head screws to 17 N·m (13 lb ft).
3.1. | Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly. |
3.2. | Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot. |
Important: The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.
Tighten
Tighten the 2 pan head tapping screws to 7 N·m (62 lb in).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 4 TORX® screws to 17 N·m (13 lb ft).
Move the linear shift assembly out of the PARK position to install the lower socket tapping screw.
Tighten
Tighten the 3 flat head tapping screws to 10 N·m
(89 lb in).
Important: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.
Tighten
Tighten the 2 pan head tapping screws to 7 N·m (62 lb in).