Linear Shift Assembly - Disassemble - Off Vehicle Column Shift

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

•	Air bag deployment

•	Personal injury

•	Unnecessary SIR system repairs

In order to avoid the above conditions, observe the following guidelines:

•	Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.

•	If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

1. Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
2. Remove the shift lever. Refer to Shift Lever Replacement - On Vehicle .
3. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle .
4. Disconnect the park lock cable assembly (1).
5. The steering column lock cylinder set should be in the OFF-LOCK position.
6. Insert a small screwdriver into the slot on the lock module assembly and push against the locking tab to remove.



7. Disconnect the automatic transmission shift lock control connector from the park position switch assembly.
8. Slide the park position switch assembly off of the linear shift assembly.




Notice: Do not use excessive force when removing the automatic transmission shift lock control from the steering column. Using excessive force may cause damage to the automatic transmission shift lock control and/or the steering column.

9. Remove the automatic transmission shift lock control from the steering column.
10. Use a small screwdriver to pry the automatic transmission shift lock control from the steering column jacket assembly.



11. Remove the 3 TORX® screws from the linear shift assembly.
12. Remove the linear shift assembly from the steering column support assembly.