• | Line up the heater/defroster lever with the mode actuator cam slot. |
• | Line up the A/C lever with the mode actuator cam. |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the mode actuator mounting screw to 1.6 N·m (14 lb in).
Notice: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.
• | Line up the heater/defroster valve lever with the mode actuator cam slot. |
• | Line up the A/C valve lever with the mode actuator cam. |
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the screws to 1.6 N·m (14 lb in).
Tighten
Tighten the screws to 1.6 N·m (14 lb in).