Step | Action | Yes | No |
---|---|---|---|
Connector End View Reference: | |||
1 | Did you perform the Engine Cooling Diagnostic System Check? | Go to Step 2 | Go to |
2 |
Does the IPC display Low Engine Coolant? | Go to Step 3 | Go to in Wiring Systems |
3 |
Does the scan tool display Low? | Go to Step 4 | Go to Step 7 |
4 |
Does the scan tool display OK? | Go to Step 8 | Go to Step 5 |
5 |
Does the scan tool display OK? | Go to Step 10 | Go to Step 6 |
6 | Inspect the coolant level signal circuit for an open or short. Refer to and in Wiring Systems. Did you find and correct the condition? | Go to Step 14 | Go to Step 9 |
7 | Inspect for poor connections at the harness connector of the IPC. Refer to and in Wiring Systems. Did you find and correct the condition? | Go to Step 14 | Go to Step 11 |
8 | Inspect for poor connections at the harness connector of the coolant level sensor. Refer to and in Wiring Systems. Did you find and correct the condition? | Go to Step 14 | Go to Step 12 |
9 | Inspect for poor connections at the harness connector of the PCM. Refer to and in Wiring Systems. Did you find and correct the condition? | Go to Step 14 | Go to Step 13 |
10 | Repair the open in the ground circuit of the coolant level sensor. Refer to in Wiring Systems. Did you Complete the repair? | Go to Step 14 | -- |
11 | Replace the IPC. Refer to in Instrument Panel, Gages and Console. Did you Complete the repair? | Go to Step 14 | -- |
12 | Replace the coolant level sensor. Refer to in Engine Controls. Did you Complete the repair? | Go to Step 14 | -- |
13 | Replace the PCM. Refer to in Engine Controls. Did you Complete the repair? | Go to Step 14 | -- |
14 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |