Removal Procedure
- Remove the power accessory
switch panel. Refer to
Power Accessory Switch Panel Replacement
.
- Disconnect the power window switch electrical connector.
- Remove the screws from the window switch.
- Remove the switch from the switch panel by lifting the rear of
the switch and sliding the switch out from the switch panel.
Installation Procedure
- Install the switch to the switch panel sliding the front tabs
in first. Rock the switch down in order to seat the switch completely.
Notice: Refer to Fastener Notice in the Preface section.
- Install the screws to the window switch.
Tighten
Tighten the window switch screws to 2 N·m (18 lb in).
- Connect the electrical connector to the window switch.
- Install the power accessory
switch panel. Refer to
Power Accessory Switch Panel Replacement
.