Assist Handle Replacement Utility Rear

1. Remove center pillar trim panel. Refer to Center Pillar Garnish Molding Replacement .
2. Remove the assist handle retraining screws.
3. Remove the assist handle from the vehicle.

1. Install the assist handle to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the assist handle screws.

Tighten
Tighten the assist handle screws to 6 N·m (53 lb in).

3. Install the center pillar trim panel. Refer to Center Pillar Garnish Molding Replacement .

Assist Handle Replacement Front

1. Lower the right side of the headliner. Refer to Headlining Trim Panel Replacement .



2. Turn the retainers in the directions as shown in the graphic and then remove the retainers.
3. Remove the assist handle from the headliner.

1. Install the assist handle through the opening in the headliner.
2. While holding the assist handle to the head liner install the retainer in the direction as shown in the graphic.
3. Install the headliner. Refer to Headlining Trim Panel Replacement .