Tools Required
• | J 39195
Converter End Play Check Tool |
- Place the
J 39195
base into the torque converter assembly
(1). The
J 39195
will bottom itself on the face of the stator.
- Insert the T-handle forcing screw of the
J 39195
into the base and hand tighten.
- Using the
J 26900-13
, position the
J 8001
so that the dial indicator tip is in the center of the
J 39195
T-handle.
- Push down on the
J 39195
T-handle to bottom the stator.
- Preload the
J 8001
.
- Set the
J 8001-3
to 0.
- Pull up on the
J 39195
T-handle.
- Inspect the reading on the dial indicator. The total end play should be 0.0-0.38 mm (0.0-0.015 in).
- Repeat this procedure several times in order to get an accurate measurement.
- Remove the tools.