- Install new O-rings to
the oil cooler assembly.
- Install a new O-ring onto the water pump outlet pipe.
- Lubricate the O-ring with engine coolant.
- Install the water pump outlet pipe to the oil filter adapter
and oil cooler assembly.
- Install the gasket for the water pump outlet pipe on the water
pump.
- Install the oil filter adapter and oil cooler assembly.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the oil filter adapter and oil cooler assembly 5 bolts.
Tighten
Tighten the oil filter adapter and oil cooler assembly bolts to 21 N·m
(15 lb ft).
- Install a new seal in
the coolant duct to the engine flywheel housing.
- Install a new gasket for the coolant duct to the oil filter adapter
and oil cooler assembly.
- Install the 2 nuts for the coolant duct to engine flywheel
housing.
- Install the 2 bolts for the coolant duct to oil filter
adapter assembly.
Tighten
• | Tighten the coolant duct bolts to 21 N·m (15 lb ft). |
• | Tighten the coolant duct nuts to 21 N·m (15 lb ft). |
- Install the engine wiring harness retainer on the water pump outlet
pipe to water pump inner stud.
- Install the water pump outlet pipe nuts.
Tighten
Tighten the water pump outlet pipe nuts to 25 N·m (18 lb ft).
- Install the oil filter.
Tighten
Tighten the oil filter to contact plus 1 to 1-1/4 turn.
- Install the cross bar
(4WD vehicle).
Tighten
Tighten the cross bar bolts to 100 N·m (74 lb ft).
- Install the cross bar
(RWD vehicle).
Tighten
Tighten the cross bar bolts to 100 N·m (74 lb ft).
- Install the oil pan skid
plate. (RWD shown).
Tighten
Tighten the oil pan skid plate bolts to 20 N·m (15 lb ft).
- Install the left front
fender wheelhouse inner panel (1).
- Install the left front tire. Refer to
Tire and Wheel Removal and Installation
in Tires and Wheels.
- Lower the vehicle.
- Fill the engine coolant. Refer to
Cooling System Draining and Filling
in Engine Cooling.
- Inspect the engine oil level and add as necessary.