Removal Procedure
- Remove the left instrument
panel insulator.
- Disconnect the accelerator cable retainer (3) from the accelerator
pedal lever (2).
- Remove the end bushing retaining clips.
- Remove the end bushings from the pivot shaft.
- Remove the accelerator pedal.
Installation Procedure
- Install the accelerator
pedal.
- Install the end bushings to the pivot shaft.
- Install the end bushing retaining clips.
- Install the accelerator cable through the slot in the accelerator
pedal lever (2).
- Seat the retainer (3) in the accelerator pedal lever (2).
- Check for complete throttle opening and closing positions by operating
the accelerator pedal. Also check for poor carpet fit under the accelerator
pedal. The throttle should operate freely without bind between full
closed throttle and wide open throttle.
- Install the left instrument panel insulator.