Removal Procedure
- Remove the heater/vent module. Refer to
Heater/Vent Module Replacement
.
- Remove the heater/vent
module screws.
- Separate the heater/vent module.
- Remove the mode actuator screws.
- Remove the mode actuator (3).
- Remove the mode actuator cam assembly (4).
- Remove the defroster door lever (2).
- Remove the defroster door (1).
Installation Procedure
- Install the defroster
door (1).
- Install the defroster door lever (2).
- Install the mode actuator cam assembly (4).
- Install the mode actuator (3).
- Install the mode actuator screws.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the mode actuator screws.
Tighten
Tighten the screws to 1.6 N·m (14 lb in).
- Install the heater/vent module halves.
- Install the screws to the heater/vent module.
Tighten
Tighten the screws to 1.6 N·m (14 lb in).
- Install the heater/vent module. Refer to
Heater/Vent Module Replacement
.