The numbers below refer to the step numbers on the diagnostic table.
Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
The presence of DTC B1000 or B1005 indicates a module self diagnostic test has detected a malfunction.
Step | Action | Yes | No | ||||
---|---|---|---|---|---|---|---|
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications | ||||
Does the scan tool communicate with the body control module? | Go to Step 4 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |||||
3 |
Important: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
Does the Class 2 Power Mode parameter reading match the ignition switch position for all the selected positions? | Go to Step 4 | Go to Power Mode Mismatch in Body Control System | ||||
4 | Select the display DTCs function on the scan tool for the following modules:.
Does the scan tool display any DTCs? | Go to Step 5 | Go to Symptoms - Doors | ||||
Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 6 | |||||
Does the scan tool display DTC B1000 or B1005? | Diagnostic Trouble Code (DTC) List in Body Control System |