Roof Panel Joint Finish Molding Replacement Standard Cab
Tools Required
J 25070 Heat Gun
Removal Procedure
- Use the J 25070
in
order to heat the molding and the surrounding sheet metal to 82-93°C
(180-200°F).
- Remove the roof joint
molding.
• | Use a flat bladed tool in order to pry off the molding between
the sealer and the joint. Use pliers or a similar tool in order to handle
the hot molding and pull the molding loose. The molding and the sealer
should come off in 1 piece. |
• | Do not damage the paint on the cab. |
- Clean the joint in order to remove any remaining sealer. Sealer
could interfere with the fit of the replacement molding.
Installation Procedure
- Use the J 25070
in order to heat the cab in the joint
area. Preheat the sheet metal to approximately 93°C (200°F).
- Install the molding.
Preheat the sheet metal in order to melt the sealer and bond the molding
into the joint. Sealer begins to flow at approximately 93°C (200°F).
Roof Panel Joint Finish Molding Replacement Extended Cab
Tools Required
J 25070 Heat Gun
Removal Procedure
- Use the J 25070
in
order to heat the molding and the surrounding sheet metal to 82-93°C
(180-200°F).
- Remove the roof joint
molding.
Use a flat bladed tool in order to pry off the molding between the sealer
and the joint. Use pliers or a similar tool in order to handle the hot molding
and pull the molding loose. The molding and the sealer should come off
in 1 piece.
Do not damage the paint on the cab.
- Clean the joint in order to remove any remaining sealer. Sealer
could interfere with the fit of the replacement molding.
Installation Procedure
Important: Preheat the sheet metal in order to melt the sealer and bond the molding
into the joint. Sealer begins to flow at approximately 93°C (200°F).
- Use the J 25070
in order to heat the cab in the joint
area. Preheat the sheet metal to approximately 93°C (200°F).
- Install the molding.