Front Floor Console Compartment Replacement Non-Luxury

1. Open the center console.



2. Remove the console storage bin screws.
3. Remove the 4 bolts retaining the console to the bracket.
4. Remove the rear cupholder by using a flat bladed tool to pry on one side out, if equipped.
5. Remove the 2 retaining screws.
6. Remove the console storage bin and lid assembly from the console.

1. Install the console storage bin and lid assembly to the console.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the 2 retaining bin screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).

3. Install the rear cupholder by pushing the unit in until the cupholder locks into place.
4. Install the 4 bolts retaining the console to the bracket.

Tighten
Tighten the bolts to 2 N·m (18 lb in).

5. Install the bin screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).

6. Close the console.

Front Floor Console Compartment Replacement Luxury

1. Open the console lid.
2. Remove the storage bin retaining screws (1).
3. Lift the storage bin out partially.
4. Disconnect the electrical connectors.
5. Lift the storage bin out of the console.

1. Partially install the bin into the console.
2. Connect the electrical connectors.
3. Allow the storage bin to seat in the console.

Notice: Refer to Fastener Notice in the Preface section.

4. Install the retaining screws (1).

Tighten
Tighten the retaining screws to 1.6 N·m (14 lb in).

5. Close the console lid.

Front Floor Console Compartment Replacement Pro

1. Open the console lid and remove the 6 retaining screws (1).



2. Remove the 4 console bin retaining bolts (1).
3. Lift the console bin and lid assembly in order to pull out the electric cord.
4. Remove the console bin and lid assembly from the console.

1. Place the console bin and lid assembly over the console in order to route the electrical cord to the console bin.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the console bin and lid assembly to the console.

Important: Ensure the rear bolts has the bigger washer.




3. Install the 4 console bin retaining bolts (1).

Tighten
Tighten the 4 bolts to 3.5 N·m (35 lb in).

Important: Ensure the longer screw is installed in the front of the console bin.




4. Install the 6 retaining screws (1).

Tighten
Tighten the 6 screws to 1.6 N·m (14 lb in).