- Remove the key from the ignition.
- Connect the IP module yellow 2-way connector (1) located behind the main IP support.
- Install the CPA to the IP module yellow 2-way connector (1) located behind the main IP support.
- Connect the steering wheel module yellow 2-way connector (2) located at the base of the steering column.
- Install the CPA (1) to the steering wheel module yellow 2-way connector (2) located at the base of the steering column.
- Install the AIR BAG Fuse to the fuse block.
- Staying well away from all air bags, turn ON the ignition, with the engine OFF.
7.1. | The AIR BAG indicator will flash 7 times. |
7.2. | The AIR BAG indicator will then turn OFF. |
- Perform the
Diagnostic System Check - SIR
if the AIR BAG indicator does not operate as described.