Removal Procedure
- Remove the I/P trim panel. Refer to
Instrument Panel Upper Trim Panel Replacement
in Instrument Panel, Gages and Console.
- Remove the antenna mast.
- Remove the outboard section of the cowl vent grille panel.
- Remove the auxiliary battery, if equipped. Refer to
Auxiliary Battery Replacement
in Engine Electrical.
- Remove the 3 bolts.
- Remove the cable grommet from the body.
- Disconnect the antenna cable from the extension cable.
- Tie a long wire to the antenna cable.
- From outside of the vehicle, pull the antenna base and cable assembly until the wire can be easily accessible.
Ensure part of the wire is still in the vehicle
- Remove the wire from the antenna cable.
Installation Procedure
- From outside the vehicle, tie the wire to the new antenna cable and base assembly.
- From inside the vehicle, pull on the long wire until the cable can be connected and grommet seated.
- Install the cable grommet to the body.
- Remove the wire and connect the antenna cable to the cable extension.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the 3 bolts.
Tighten
Tighten the bolts to 5 N·m (44 lb in).
- Install the auxiliary battery, if equipped. Refer to
Auxiliary Battery Replacement
in Engine Electrical.
Notice: Use tape on the tool surface so that you do not damage the paint on
the antenna mast.
- Install the antenna mast.
Tighten
Tighten the mast to 6 N·m (53 lb in).
- Install the outboard section of the cowl vent grille panel.
- Install the I/P trim panel. Refer to
Instrument Panel Upper Trim Panel Replacement
in Instrument Panel, Gages and Console.