Radio Front Floor Console Speaker Replacement Tweeter

1. Remove the center console bezel. Refer to Floor Console Bezel Replacement in Instrument Panel, Gages, and Console.



2. Remove the speaker retaining nuts (1).
3. Disconnect the wire connector (2).
4. Remove the speaker from the console.

1. Install the speaker to the console.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: Do not exceed torque specification. Over tightening of the nuts will result in the stud breaking from the console.

2. Install the retaining nuts.

Tighten
Tighten the retaining nuts to 0.7 N·m (6.2 lb in).

3. Connect the electrical connector (2).
4. Install the center console bezel. Refer to Floor Console Bezel Replacement in Instrument Panel, Gages, and Console.