Tools Required
• | J 42137 Cam
Orientation Plate Adapter |
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the inflatable restraint steering wheel module.
Refer to
Disabling the SIR System
in
SIR.
Important: Let the inflatable restraint steering wheel module coil hang freely
after removal.
- Remove the inflatable restraint steering wheel module coil. Refer to
Inflatable Restraint Steering Wheel Module Coil Disassemble - Off Vehicle
.
- Remove the bearing retainer using J 23653-SIR
and J 42137
.
- Remove J 23653-SIR
and J 42137
.
- Discard the bearing retainer.
- Remove the following parts
from the steering shaft assembly:
6.1. | The cam orientation plate (4) |
6.2. | The turn signal cancel cam assembly (3) |
6.3. | The upper bearing spring (2) |
6.4. | The thrust washer (1) |