GM Service Manual Online
For 1990-2009 cars only

Fuel Pump Replacement Cab/Chassis

Removal Procedure


    Object Number: 877754  Size: SH
  1. Loosen the fuel fill cap to relieve the fuel system pressure.
  2. Disconnect the fuel pump electrical connector (1).
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

  4. Object Number: 19670  Size: SH
  5. Clean the fuel pipe connections and surrounding areas at the pump before disconnecting to avoid possible fuel system contamination.
  6. Disconnect the fuel pipes from the pump.

  7. Object Number: 19671  Size: SH
  8. Slide the pump out of the bracket.
  9. Cap the fuel pipes.

Installation Procedure


    Object Number: 19671  Size: SH
  1. Remove the caps from the fuel pipes.
  2. Install the NEW fuel pipe O-rings.
  3. Position the new pump in the pump bracket.

  4. Object Number: 19670  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Connect the fuel pipes to the fuel pump. Use a backup wrench to prevent the pump from turning.
  6. Tighten
    Tighten the fittings to 30 N·m (22 lb ft).

  7. Lower the vehicle.

  8. Object Number: 877754  Size: SH
  9. Connect the fuel pump electrical connector (1).
  10. Install the fuel fill cap.