GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2004 🢒 GMC C Sierra - 2WD 🢒 Engine 🢒 Engine Controls - 6.6L (LB7) 🢒 Fuel Feed Pipe Replacement - Fuel Junction Block to Fuel Injection Pump

Removal Procedure

    Object Number: 877275 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  3. Loosen the charged air cooler outlet duct clamp (1).

    4. Important: Do not use a screwdriver or other tool to pry the hose loose. The hose cam be torn or damaged. Loosen the hose by twisting.

  4. Remove the charged air cooler outlet duct.

    5. Object Number: 877281 Size: SH
  5. Loosen the charged air cooler inlet duct to turbocharger clamp (1).
  6. Remove the charged air cooler inlet duct from the turbocharger.
  7. Remove the engine wiring harness. Refer to Engine Wiring Harness Assembly Replacement .
  8. Remove the water outlet tube. Refer to Water Outlet Tube Replacement in Engine Cooling.

    9. Object Number: 791907 Size: SH
  9. Remove the junction block to fuel injection pump fuel feed pipe.

Installation Procedure

    Object Number: 791907 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the junction block to fuel injection pump fuel feed pipe.

    2. Tighten
    Tighten the fitting to 41 N·m (30 lb ft).

  2. Install the water outlet tube. Refer to Water Outlet Tube Replacement in Engine Cooling.

    3. Object Number: 877281 Size: SH
  3. Install the engine wiring harness. Refer to Engine Wiring Harness Assembly Replacement .
  4. Install the charged air cooler inlet duct to the turbocharger.
  5. Align the mark on the duct (2) with the mark on the turbocharger.
  6. Position the clamp (1) as shown for proper clearance.

    7. Tighten
    Tighten the clamp to 6 N·m (53 lb in).


    Object Number: 877275 Size: SH
  7. Install the charged air cooler outlet duct to the intake.
  8. Align the mark on the duct (3) with the mark on the turbocharger.
  9. Position the clamp (1) as shown for proper clearance.

    10. Tighten
    Tighten the clamp to 6 N·m (53 lb in).

  10. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  11. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.