For 1990-2009 cars only
Removal Procedure
- Disconnect the electrical connector from the back of the mirror.
- Remove the wire cover.
- Adjust the mirror to the full upward position.
- Remove the base trim cover.
- Loosen the screw (3) in order to remove the mirror (2) from the button assembly (1).
- Slide the mirror assembly in an upward motion in order to remove.
Installation Procedure
- Position the center bottom of the mirror mount against the windshield at the top of the support button (1).
- Slide the base of the mirror onto the button.
- Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.
- Install the base trim cover.
- Connect the electrical connector.
- Install the wire cover.
- Reposition the mirror assembly.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screw (3) to 1.8 N·m (16 lb in)
in order to secure the mirror base to the button.
