GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2004 🢒 GMC C Sierra - 2WD 🢒 Steering 🢒 Power Steering System 🢒 Power Steering Fluid Reservoir Replacement - Off Vehicle

Removal Procedure

    Object Number: 1742672 Size: SH
  1. Drain the power steering fluid from the power steering pump.
  2. Remove the pump mounting studs (2).
  3. Remove the connector and fitting assembly (3).
  4. Remove the O-ring seal (4) from the connector and fitting assembly (3).
  5. If replacement is required, remove the control valve assembly and the flow control spring from the pump housing assembly; refer to Power Steering Pump Flow Control Valve Replacement - Off Vehicle .

    6. Object Number: 431061 Size: SH
  6. Remove the reservoir assembly (1) from the pump housing assembly (2).

    7. Object Number: 404947 Size: SH
  7. Remove the O-ring seals (1) (4).
  8. Remove the magnet (3).
  9. Clean the magnet (3).
  10. Inspect the welch plug in the power steering pump housing (2). Do not remove. If the welch plug is deformed or dislodged, replace the power steering pump housing (2).

Installation Procedure

    Object Number: 404947 Size: SH

    Important: Use new O-ring seals when assembling the power steering pump assembly.

  1. Lubricate the O-ring seals (1) (4) with power steering fluid.
  2. To install the control valve assembly and flow control spring to the pump housing assembly (2); refer to Power Steering Pump Flow Control Valve Replacement - Off Vehicle .
  3. Install the O-ring seals (1) (4) to the pump housing assembly (2).
  4. Install the magnet (3) to the pump housing assembly (2).

    5. Object Number: 431061 Size: SH
  5. Connect the reservoir assembly (1) to the pump housing assembly (2).
  6. Install the O-ring seal.

    7. Object Number: 1742672 Size: SH
  7. Install the O-ring (4) onto the connector and fitting assembly (3).
  8. Install the connector and fitting assembly (3).

    9. Notice: Refer to Fastener Notice in the Preface section.

  9. Install the pump mounting studs (2) to the pump housing (1).

    10. Tighten
    Tighten the pump mounting studs (2) to 58 N·m (43 lb ft).

    Tighten
    Tighten the connector and fitting assembly (5) to 75 N·m (55 lb ft).