DTC P0A8E APM Voltage High
Circuit Description
The purpose of the accessory power module (APM), integral to the starter/generator control module (SGCM), is to control the amount and direction of energy flowing between the 42v DC and 14v DC Buses via the APM, bi-directional 42v DC to 14v DC converter. All APM functions shall only be run when in the enable mode. APM current shall be defined as the current flowing through the outputs. APM power is bi-directional, with negative current representing 14-42 direction, and positive current representing the 42-14 direction.
When the APM Power Conversion direction is set to a value of 42v to 14v, the energy shall flow from the 42v DC Bus to the 14v DC Bus via the APM. When the Service Charge or jump start is requested, the energy shall flow from the 14v DC Bus to the 42v DC Bus via the APM. When the APM Power Conversion direction is set to a value of Off, the APM shall be turned OFF and not consume or transfer any power. When the APM Power Conversion direction is set to a value of Invalid, the energy shall flow from the 42v DC Bus to the 14v DC Bus via the APM.
Conditions for Running the DTC
| • | Engine is running for 30 seconds. |
| • | The SGCM has received voltage on the ignition 0 voltage circuit. |
| • | The SGCM has turned ON and no configuration DTC is present. |
| • | This diagnostic shall run every 100 milliseconds. |
Conditions for Setting the DTC
APM voltage is set above 26.5 volts.
Action Taken When the DTC Sets
| • | The powertrain control module (PCM) stores the DTC information into memory when the diagnostic runs and fails. |
| • | The malfunction indicator lamp (MIL) will not illuminate. |
| • | The PCM records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records. |
| • | The driver information center (DIC), if equipped, may display a message. |
Conditions for Clearing the DTC
| • | A current DTC Last Test Failed clears when the diagnostic runs and passes. |
| • | A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic. |
| • | Clear the DTC with a scan tool. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Starting and Charging Schematics Connector End View Reference: Engine Electrical Connector End Views | |||
1 | Was the Engine Electrical Diagnostic System Check performed? | Go to Step 2 | |
2 |
Is the DTC set as current DTC? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
3 | Inspect for poor connections at the harness connector of the starter/generator control module (SGCM) . Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 5 | Go to Step 4 |
4 | Replace the SGCM. Refer to Generator Control Module Replacement . Did you complete the replacement? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 2 | System OK |
