Schematic Reference: Outside Rearview Mirror Schematics

Connector End View Reference: Power Door Systems Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Turn ON the ignition, with the engine OFF.
2. Place the mirror select switch in the neutral fold position.
3. Activate the mirror direction switch in the left/extend and right/retract positions.

Do the outside rearview mirrors extend and retract with the corresponding switch activation?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Are both folding mirrors inoperative?

Go to Step 4

Go to Step 5

1. Install a scan tool.
2. Monitor the mirror select switch and the mirror switch data parameters.
3. Activate the mirror select switch left, right and neutral/fold positions.
4. Activate the left/extend and right/retract functions from the mirror switch.

Do all of the data parameters change with the corresponding switch activations?

Go to Step 5

Go to Step 6

1. Install a scan tool.
2. With the scan tool, observe the Mirror Folding Operation data parameter in the appropriate door module data list.
3. Command the inoperative mirror to retract and extend using the mirror switch.

Does the Mirror Folding Operation data parameter change states with the corresponding command?

Go to Step 7

Go to Step 8

Inspect for poor connections at the driver door module (DDM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 9

Inspect for poor connections at the power mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 10

Inspect for poor connections at the appropriate door module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 11

Replace the DDM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the repair?

Go to Step 12

--

Replace the power mirror. Refer to Outside Rearview Mirror Replacement .

Did you complete the repair?

Go to Step 12

--

Replace the appropriate door module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the repair?

Go to Step 12

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3