Schematic Reference: Interior Lights Schematics

Connector End View Reference: Lighting Systems Connector End Views , Computer/Integrating Systems Connector End Views in Computer/Integrating Systems, or Master Electrical Component List

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Verify that the courtesy/dome lamps are always ON.

Do the courtesy/dome lamps operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Ensure that the instrument panel lamp dimmer switch is in the minimum brightness position.
2. Inspect for the following related body control module (BCM), driver door module (DDM), and passenger door module (PDM) data parameters. Refer to Scan Tool Data List and Scan Tool Data Definitions for typical values and definitions:

•	The courtesy lamp switch

•	The interior lamp defeat switch

•	The door ajar switches

Was a problem found?

Go to Step 4

Go to Step 8

Disconnect and test the switch of the affected input circuit for proper continuity in the open and closed positions. Refer to Testing for Continuity in Wiring Systems.

Is continuity correct in both positions?

Go to Step 5

Go to Step 6

Test the signal circuits of the affected input switch for a short to ground or the courtesy lamp defeat switch signal circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 7

Inspect for poor connections at the harness connector of the affected switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 9

Inspect for poor connections at the harness connector of the module in the affected circuit. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 10

Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 11

Replace the switch in the affected circuit.

Did you complete the replacement?

Go to Step 12

--

Replace the module in the affected circuit. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 12

--

Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 12

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3