INDICATED ENGINE OVERHEAT SHORTLY AFTER START-UP

VEHICLES AFFECTED: 1987 'M' AND 'G' VANS AND 1988 'C/K' TRUCKS WITH 4.3L (VIN CODE Z), 5.OL (VIN CODE H), AND 5.7L (VIN CODE K)

Some 1987 'M' and 'G' vans and 1988 'C/K' trucks with 4.3L, 5.0L, and 5.7 engines which use a serpentine accessory drive belt and a reverse rotation water pump, may experience an indicated engine overheat (temperature gauge needle past the red mark) condition during warm-up. The water pumps contain highly efficient curved blade type impellers and under a certain combination of clearances, the impeller discharges a larger quantity of coolant to the right engine bank than to the left engine bank. This condition usually occurs under closed thermostat operation because the recirculating coolant flows only from the right cylinder head to the right side of the water pump. As a result, left bank coolant flow can be lower until the thermostat opens, causing the indicated overheat condition. The coolant sensor for the dash indicator is located in the left head. Excessive flow to the right bank can also cause lower coolant temperature and poor heater performance. This condition can be repaired using the following procedure.

Checking Procedure:

1. Check coolant level.

2. Check temperature sensing system (sender and gauge).

a. Gauge needle is below 100 degrees Fahrenheit when engine is cold and gauge needle not swinging below normal operating temperature when engine has been warmed up.

NOTICE: AN INDICATED OVERHEAT USUALLY CAUSES A SWINGING TEMPERATURE GAUGE NEEDLE OR A NEEDLE STUCK PAST THE RED MARK .

Repair Procedure:

1. Remove water pump using procedures in section 6B (Engine Cooling) of the appropriate service manual.

2. Remove back cover on the water pump by removing six machine screws. Remove gasket.

3. Using a pencil grinder, grind away the cast ridge (approximately 0.150" high by about 0.5" wide) at the bottom inside of the pump body (See Illustration).

a. Place rags to immobilize impeller and to gain maximum access to the ridge and to keep grinding metal particles from entering the pump bearing and seal.

4. Remove metal particles and rags.

5. Clean pump body and cover. Reinstall back cover using a new gasket, P/N 3782611.

6. Reinstall water pump.

7. Retest vehicle for condition.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.