GAP AT SERIES EMBLEM AND BODY SIDE MOLDING

MOULDING - SERIES EMBLEM TO BODY SIDE MOULDING GAP

VEHICLES AFFECTED: 1988 C/K TRUCK -----------------

Some 1988 C/K models may have a gap between the series emblem and the body side moulding on the front door.

If this gap exists, it can be eliminated by performing the following procedure:

* Remove series emblem from the body side moulding.

Note: Removal is accomplished by pulling or prying.

* Clean all dirt, oil and grease from the back of the series emblem and the body side moulding.

* Using 3M tape P/N 6379 or 6380 or equivalent, cut two pieces three inches long.

* Apply the two pieces of tape to the back of the series emblem as shown in Figure 1.

* Remove protective backing from each piece and reattach the emblem to the door.

* Using a roller, firmly press the emblem to the body side moulding several times to ensure full tape contact.

* Repeat this procedure on the opposite door if this condition exists.

DISCLAIMER

"We believe this source and their material to be reliable. There may be additional manufacturers of such material. General Motors does not endorse, indicate any preference for or assume any responsibility for the products or equipment from these firms or for any such items which may be available from other sources."

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.