SOME OWNERS MAY COMMENT THAT THE LOWER CORNER(S) OF THE GRILL PROTRUDE OUTBOARD OF THE FENDER.
SECURE THE LOWER CORNERS OF THE GRILL USING THE FOLLOWING STEPS.
1. RAISE THE HOOD AND REMOVE THE FOUR SCREWS HOLDING THE PARKING LAMP HOUSING. 2. DISCONNECT THE TWO LAMP SOCKETS IN THE PARKING LAMP HOUSING AND LOOSEN THE SCREW THAT ATTACHES THE GRILL TO THE RADIATOR SUPPORT. THIS WILL ALLOW THE CORNER OF THE GRILL TO BE MOVED INTO PROPER ALIGNMENT WITH THE FENDER. 3. WORKING FROM UNDER THE FRONT BUMPER, HOLD THE LOWER CORNER OF THE GRILL IN ALIGNMENT TO THE FENDER AND DRILL A 1/8 INCH (.125") DIAMETER HOLE THROUGH THE VERTICAL CAVITY IN THE BUMPER FILLER PANEL IN LINE WITH THE CENTER OF THE SIDE MARKER LENS (FIGURE 1). CONTINUE DRILLING THROUGH THE BOTTOM FLANGE OF THE GRILL. 4. THROUGH THE PARK LAMP CAVITY IN THE GRILL, DRIVE SCREW, P/N 11515303, THROUGH THE BOTTOM FLANGE OF THE GRILL AND INTO THE BUMPER FILLER PANEL. 5. REATTACH PARTS REMOVED IN STEPS 1 AND 2.
SERVICE PARTS INFORMATION
P/N DESCRIPTION QTY 11515303 SCREW 2
PARTS ARE CURRENTLY AVAILABLE FROM GMSPO.
WARRANTY INFORMATION
FOR VEHICLES REPAIRED UNDER WARRANTY, USE:
LABOR OP DESCRIPTION LABOR TIME B1880 FENDER, RIGHT FRT - ALIGN USE PUBLISHED B1881 FENDER, LEFT FRT - ALIGN LABOR OPERATION TIME
FIGURES: 1
CAPTIONS: FIGURE 1
GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.
COPYRIGHT 1996 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.