- Inspect for properly installed oil pump locating pins.
- Assemble the oil pump, driveshaft, and a NEW retainer.
- Install the oil pump assembly.
- Install the bolt attaching the oil pump to the rear crankshaft bearing cap.
Important: During assembly, install a NEW oil pump driveshaft retainer. Slightly heat retainer above room temperature for ease of installation onto the oil pump driveshaft.
Position the oil pump onto the locating pins.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the oil pump bolt to 88 N·m (65 lb ft).
