GM Service Manual Online
For 1990-2009 cars only

Excessive resistance caused by poor terminal connections and partial short circuits through worn cable insulation will result in an abnormal voltage drop in the starter cable. Low voltage at the starter will prevent the normal starter operation and cause hard starting.


Object Number: 105120  Size: SH

Whenever the battery cables (3) are replaced, use a replacement cable that is the same in the type, the diameter, and the length. Some positive cables have additional feed wires attached to them and some of the negative cables have additional ground leads attached.


Object Number: 105121  Size: SH

Object Number: 105120  Size: SH

Ensure that replacement battery cables are routed to the battery (2) in the same manner as the original.

Caution: In order to prevent possible personal injury from a moving vehicle or from an operating engine, perform the following steps before performing the checks:

  1. Place the transmission in park.
  2. Engage the parking brakes and block the wheels.
  3. Disconnect the battery feed at the distributor.

Notice: When installing the positive battery cable to the starter solenoid, the inner nut on the solenoid battery terminal must be tightened before the battery cable and the other leads are installed. Failure to do so will result in the solenoid or the solenoid terminal damage.

  1. Inspect the voltage drop between the ground (the negative battery terminal) and the vehicle frame.
  2. Place one probe of the J 39200 on the grounded battery post (not on the cable clamp) and the other on the frame.

    Operate the starter and note the voltage reading.

  3. Inspect the voltage drop between the positive battery terminal (3) and the starter terminal stud with the starter operating.
  4. Inspect the voltage drop between the starter housing and the frame with the starter operating.
  5. If the voltage drop in any of the above is more than 0.5 volts, there is excessive resistance in the circuit.
  6. In order to eliminate resistance, the cables should be disconnected and the connections should be cleaned.

    If the cables are frayed or the clamps are corroded, the cables should be replaced.

    When selecting the new cables, ensure that the new cables are the same length and the same diameter as the original cables being replaced.