GM Service Manual Online
For 1990-2009 cars only

Steering Column Trim Covers - Assemble - Off Vehicle Column Shift

Tools Required

J 41352 Modular Column Holding Fixture


    Object Number: 324816  Size: SH
  1. Install the trim cover protector (1) to the lower trim cover (2).

  2. Object Number: 324810  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the upper trim cover (2) and secure by using the TORX® head screw (1).
  4. Tighten
    Tighten the screw to 1.5 N·m (13 lb in).

  5. The shift lever seal must seat in the trim covers.

  6. Object Number: 324805  Size: SH
  7. Install the lower trim cover (1) and secure by using the 2 pan head tapping screws (2).
  8. Tighten
    Tighten the screws to 3.5 N·m (31 lb in).


    Object Number: 360562  Size: SH
  9. Take the column out from J 41352 .

Steering Column Trim Covers - Assemble - Off Vehicle Floor Shift

Tools Required

J 41352 Modular Column Holding Fixture


    Object Number: 324816  Size: SH
  1. Install the trim cover protector (1) to the lower trim cover (2).

  2. Object Number: 324810  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the upper trim cover (2) and secure by using the TORX® head screw (1).
  4. Tighten
    Tighten the screw to 1.5 N·m (13 lb in).


    Object Number: 324805  Size: SH
  5. Install the lower trim cover (1) and secure by using the 2 pan head tapping screws (2).
  6. Tighten
    Tighten the screws to 3.5 N·m (31 lb in).


    Object Number: 360562  Size: SH
  7. Take the column out from J 41352 .