GM Service Manual Online
For 1990-2009 cars only

Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle Column Shift


    Object Number: 324882  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.
  2. Tighten
    Tighten the screws to 4.7 N·m (42 lb in).

  3. Install the key alarm connector (1) onto the lock module assembly (2).

  4. Object Number: 306234  Size: SH
  5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulk head connector (1).

  6. Object Number: 360577  Size: SH
  7. Pop the wire harness assembly (4) into the wire harness strap (5).
  8. Install the wire harness strap (2) into the steering column tilt head assembly (1).

    Install the wire harness straps (3) onto the wire harness assembly (4).

  9. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .

Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle Floor Shift


    Object Number: 324882  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the ignition and key alarm switch assembly (3) onto the lock module assembly (2) and secure by using 2 tapping screws.
  2. Tighten
    Tighten the screws to 4.7 N·m (42 lb in).

  3. Install the key alarm connector (1) onto the lock module assembly (2).

  4. Object Number: 306234  Size: SH
  5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulk head connector (1).

  6. Object Number: 360577  Size: SH
  7. Pop the wire harness assembly (4) into the wire harness strap (5).
  8. Install the wire harness strap (2) into the steering column support assembly (1).

    Install the wire harness straps (3) onto the wire harness assembly (4).

  9. Install the upper and lower trim covers. refer to Steering Column Trim Covers - Assemble - Off Vehicle .