- Remove the key from the ignition switch.
- Connect the passenger
yellow 2-way connector (1) located near the base of the steering column.
- Install the Connector Position Assurance (CPA) (2) to the
passenger yellow 2-way connector located near the base of the steering column.
- Connect the driver yellow
2-way connector (2) located at the base of the steering column.
- Install the Connector Position Assurance (CPA) (1) to the
driver yellow 2-way connector located at the base of the steering column.
- Install the AIR BAG Fuse to the IP fuse block.
- Staying well away from the air bags, turn ON the ignition.
7.1. | The AIR BAG warning lamp will flash 7 times. |
7.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described. Refer to
SIR Diagnostic System Check